Intermec 751G - Manual (Page 69)

Chapter 3 — Configuring the Computer
751G Color Mobile Computer User’s Manual 55
Example
[CEDevice]
UnsupportedPlatforms = pltfrm1 ; pltfrm1 is unsupported
[CEDevice.SH3]
UnsupportedPlatforms = ; pltfrm1 is still unsupported
Example
The following code example shows three [CEDevice] sections: one that
gives basic information for any CPU and two that are specific to the SH3
and the MIPS microprocessors.
[CEDevice] ; A “template” for all platforms
UnsupportedPlatforms = pltfrm1; Does not support pltfrm1
; The following specifies version 1.0 devices only.
VersionMin = 1.0
VersionMax = 1.0
[CEDevice.ARM]; Inherits all [CEDevice] settings
; This will create a .CAB file specific to ARM devices.
ProcessorType = 2577; ARM .cab file is valid for ARM microprocessors.
UnsupportedPlatforms = ; pltfrm1 is still unsupported
; The following overrides the version settings so that no version checking is
performed.
VersionMin =
VersionMax =
[CEDevice.MIPS] ; Inherits all [CEDevice] settings
; This will create a .CAB file specific to “MIPS” devices.
ProcessorType = 4000; MIPS .CAB file is valid for MIPS microprocessor.
UnsupportedPlatforms =pltfrm2; pltfrm1, pltfrm2 unsupported for MIPs .CAB
file.
VersionMin minor_version Numeric value returned by OSVERSIONINFO.dwVersionMinor. The .cab file is valid for
the currently connected device if the version of this device is greater than or equal to
VersionMin.
VersionMax major_version Numeric value returned by OSVERSIONINFO.dwVersionMajor. The .cab file is valid for
the currently connected device if the version of this device is less than or equal to
VersionMax.
BuildMin build_number Numeric value returned by OSVERSIONINFO.dwBuildNumber. The .cab file is valid for
the currently connected device if the version of this device is greater than or equal to
BuildMin.
BuildMax build_number Numeric value returned by OSVERSIONINFO.dwBuildNumber. The .cab file is valid for
the currently connected device if the version of this device is less than or equal to BuildMax.
Note: To create the two CPU-specific .cab files for the Setup.inf file in the
previous example, run the CAB Wizard with the “/cpu arm mips”
parameter.