Intermec 751G - Manual (Page 30)

Chapter 1 — Using the Computer
16 751G Color Mobile Computer User’s Manual
Accessing the Secure Digital Card Slot
To access the card slot, locate the access door at the top of the 751G, loosen
its two screws, then remove the door. Note that the screws to this door are to
be torqued to 1.5 in-lbs. See the Model 751G Mobile Computer Quick Start
Guide (P/N 962-054-093) for more information.
This illustration shows the top of the 751G. Note the keypad is to the bottom.
Internal Card Slots and Connector
Below is a view of the various card slots within your 751G. Note that you
only have access to the Secure Digital card slot. The other two slots are
embedded into the unit and cannot be removed.
• A radio is embedded in the CompactFlash card slot and is not accessible.
• The Secure Digital card goes into the bottom left card slot.
• The SmartCard adapter plugs into the 6-pin connector in the bottom
right.
This illustration shows the top of the 751G. Note the keypad is to the bottom.
Attaching a Tab to the Secure Digital Card
The Secure Digital storage card, as ordered from Intermec, come with
acrylic adhesive pull tabs. If you are using a storage card that you plan to
remove from the 751G, this tab can make its removal easier.
Do the following to attach the tab to your storage card. Note that the pull
tab has divots cut into either side, towards the shorter end. Use these divots
as a guide.
1 Completely peel the paper off the short end of the tab. Partially pull the
paper off the long end of the tab away from the divots. Fold the short
end under, at the divots, to stick to itself.
Storage Media Access Door
CompactFlash card slot
6-pin connector
Secure Digital card slot
Short end of pull tab
Fold line at divots Long end of pull tab