Intelligent Motion Systems MForce PowerDrive Plus MForce Series Microstepping PowerDrive - Manual (Page 21)

3 Part 2: Interfacing and Configuring
SECTION 2.1
Mounting and Connection Guidelines
Mounting Recommendations
The Microstepping MForce PowerDrive may be mounted two ways: end mounted or flat mounted End mount-
ing will use #8 hardware, flat mounting will use standard #6 hardware. Do not exceed the recommended mount-
ing torque specification. The diagrams in Figures 2.1.1 and 2.1.2 illustrate the mounting methods.
Figure 2.1.1: Base Mounting the MForce PowerDrive
4 x #6-32 Screw
4 x #6 Split Lockwasher
4 x #6 Flat Washer
Mounting Hardware
4 x M3.5 - 0.60 Screw
4 x M3.5 Split Lockwasher
4 x M3.5 Flat Washer
Mounting Hardware (Metric)
MForce PowerDrive
Mounting Surface
2.931 TYP
(74.45 TYP)
2.950
(74.93
Use #36 Drill Size (2.9 mm)
Tap to #6-32 (M3.5 - 0.60) 4 PL
Mounting Hole Pattern
(Not to Scale)
Recommended Tightening Torque:
7 - 8 lb-in (78.4 - 89.6 N-cm)
NOTE: Mounting
Hardware is not
supplied.