IBM Enterprise Server H80 Series - Manual (Page 178)

Step 14
The diagnostics produced a SRN for this problem. Do the following:
1. Record the SRN.
2. Report the SRN to the service organization.
3. STOP. You have completed these procedures.
Step 15
When you are loading the Standalone Diagnostics, the attributes for the terminal
must be set to match the defaults of the diagnostic programs. The ASCII terminal
must be attached to Serial Port 1 on the system unit.
Are you going to load Standalone Diagnostics and run them from a ASCII
terminal?
NO Go to “Step 16” on page 163.
YES Go to “Running the Diagnostics from a TTY Terminal” on page 97 and
make sure your terminal attributes are set to work with the diagnostic
programs.
Return to “Step 16” on page 163 when you finish checking the attributes.
Record any settings that were changed.
162 RS/6000 Enterprise Server Model H80 Series User's Guide