IBM Enterprise Server H80 Series User Manual
Page 213
done
retry:
send "A/"
# Repeat the previous command.
# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r" busy "7\r"
timeout 6
done
disconnect:
delay 2
# Separate from previous data.
send "+++"
# Assure command mode.
delay 2
# Allow mode switching delay.
send "ATH T\r"
# Set modem switch-hook down
#
(i.e., hang up).
ignore " \r" or "OK\r" timeout 2
# Ignore modem response.
send "ATE Q1\r"
# Initialize modem: Echo OFF,
#
Disable responses.
ignore " \r" timeout 1
done
condin:
send "AT&FQ T\r"
# Reset to factory defaults.
ignore " \r" or "OK\r\n" timeout 2
# Ignore modem response.
send "ATE T\r"
# Initialize modem: Echo OFF,
expect " \r" or "OK\r\n" timeout 2
#
Enable responses (Numeric),
send "ATQ V X T\r"
#
Limit response codes.
expect " \r" timeout 2
# Confirm commands successful.
send "ATS =2\r"
# Set AutoAnswer ON
expect " \r" timeout 2
# Confirm command successful.
send "AT&C1&D2\r"
# Detect carrier and DTR.
expect " \r" timeout 2
# Confirm command successful.
done
waitcall: ignore "2\r" timeout 1
# Ignore first ring.
expect "2\r" timeout 1
# Pick up second ring
#
or timeout.
# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r"
timeout 6
done
page:
send "ATDT%N,,,,%R;\r"
# %N = pager call center number
# Add enough commas to wait for
#
time to enter paging number.
# %R = paging number
# Confirm successful command.
expect " \r" timeout 6
delay 2
# Wait before hanging up.
send "ATH T\r"
# Hang up.
expect " \r" timeout 2
# Confirm successful command.
done
Appendix D. Modem Configurations
197