Replacing heel loops, Raising/lowering elevating front riggings – Invacare Adjustable ASBA Seat User Manual
Page 27
SECTION 6—FRONT RIGGINGS
27
CAUTION
Make sure coved spacers are positioned properly when reassembling to prevent
damage to the frame mounting tubes.
6. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Footrests on
7. Reinstall any accessory onto the footrest(s).
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 6.6.
1. Note the position of hex bolt, coved washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and
locknut that secure the heel loop to the
lower footrest.
5. Slide the heel loop off the lower
footrest.
6. Replace heel loop.
7. Reverse STEPS 1‐6 to reassemble.
NOTE: When securing heel loop to lower
footrest, tighten the phillips bolt and locknut
until the spacer is secure.
FIGURE 6.6 Replacing Heel Loops
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 6.7.
1. Perform one of the following:
• Raising ‐ Pull back on the release
lever and raise front rigging to the
desired height.
• Lowering ‐ Support front rigging
with one hand away from the
release lever. Push release lever
downward with other hand.
FIGURE 6.7 Raising/Lowering Elevating
Footrest Support
Hex Bolt
Phillips Bolt
Spacer
Heel
Loop
Locknut
Lower Footrest
Coved
Washer
Locknut
Release
Lever