Invacare Adjustable ASBA Seat - Manual (Page 34)

SECTION 7—POWER ELEVATING LEGRESTS
Adjustable ASBA Seat 34 Part No 1143238
SECTION 7—POWER ELEVATING
LEGRESTS
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustments or service, ALWAYS turn the
wheelchair power off, otherwise injury or damage may result.
Installing/Removing the Power Elevating Legrests
ƽ WARNING
To prevent personal injury, ALWAYS verify proper positioning of legs and feet prior
to use. Individual user weight may impact the rate of travel for each legrest
assembly. If simultaneous operation is desired, select a speed which allows for the
most uniform travel.
DO NOT insert fingers between legrest components, otherwise personal injury may
occur.
ࣼ CAUTION
NEVER allow items to become trapped between the legrest assemblies, otherwise
damage to the power legrests may occur.
Ensure that all parts of both power legrests are clear of any obstructions before
raising and lowering. Otherwise damage to the power legrests may occur.
NOTE: For this procedure, refer to FIGURE 7.1 on page 35.
Installing the Power Elevating Legrests
1. Turn power legrest to side (open footplate is perpendicular to wheelchair) and align
the mounting pin on the legrest with mounting hole in the hanger assembly
(Detail “A”).
2. Insert the mounting pin of power legrest into the mounting hole of the hanger
assembly (Detail “A”).
NOTE: Make sure the legrest sits flush on the hanger assembly.
3. Rotate the power legs toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1‐3 for the opposite legrest.
5. Connect power legrest connector to the harness (Detail “B”).