Invacare Adjustable ASBA Seat - Manual (Page 28)

SECTION 6—FRONT RIGGINGS
Adjustable ASBA Seat 28 Part No 1143238
Adjusting/Replacing Telescoping Front Rigging Support
ƽ WARNING
If the telescoping tubes need to be extended greater than two inches, then the seat
MUST be repositioned rearward to ensure stability - otherwise personal injury and/
or damage to the wheelchair and surrounding property may result.
NOTE: For this procedure, refer to FIGURE 6.8.
1. Remove the two cap screws, spacers and threaded blocks securing the telescoping
front tube to the side rail.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of six depth positions.
• Remove existing telescoping front rigging.
3. Secure the telescoping front tube to the side rail at the desired depth with the existing
two cap screws, spacers and threaded blocks.
4. Repeat STEPS 1 to 3 on the opposite side if desired.
FIGURE 6.8 Adjusting/Replacing Telescoping Front Rigging Support
Telescoping
Front Tube
Cap Screws
Spacers
Threaded
Blocks
Cap Screws
Spacers
Side Rail
Side Rail