Invacare Adjustable ASBA Seat User Manual
Page 36
SECTION 7—POWER ELEVATING LEGRESTS
36
2. Loosen, but DO NOT remove, the two exterior button screws that secure the footplate
assembly to the T‐nuts.
3. Loosen, but DO NOT remove, the two button screws that secure the heel loop to the
T‐nuts.
4. Slide footplate assembly up or down, until desired height is achieved.
5. While holding footplate assembly in position, tighten all six button screws that were
loosened in STEPS 1‐3.
6. Repeat STEPS 1‐5 for opposite footplate if necessary.
NOTE: If this procedure does not provide enough length, adjust the length of the power legrest.
Refer to Adjusting the Length for Power Legrest on page 39.
FIGURE 7.2 Adjusting the Footplate Height
Adjusting the Footplate Depth
NOTE: For this procedure, refer to
FIGURE 7.3.
1. Remove the two flat head screws and
the two barrel nuts that secure the
footplate to the footplate clamp.
2. Reposition the footplate on the
footplate clamp.
3. Align the desired depth adjustment
holes on the footplate to the mounting
holes on the footplate clamp.
FIGURE 7.3 Adjusting the Footplate Depth
4. Insert the barrel nuts through the bottom of the footplate clamp.
5. Install the two flat head screws through the footplate and footplate clamp.
6. Securely tighten with two barrel nuts.
7. Repeat STEPS 1‐6 for opposite footplate if necessary.
Exterior Rail
Channel
T-Nuts (NOT SHOWN)
Footplate
Assembly
Exterior
Button Screws
Outside View
Inside View
Exterior Rail
Channel
T-Nuts (NOT SHOWN)
Footplate Assembly
Interior Button
Screws
Button Screws
for Heel Loop
Footplate Clamp
Flat Head Screws
Depth
Adjustment
Holes
Barrel Nuts
Footplate
Mounting Holes