Invacare Adjustable ASBA Seat - Manual (Page 69)

SECTION 12—JUNIOR SEATS
Part No 1143238 69 Adjustable ASBA Seat
2. 12 to 13‐inch Seat Widths ‐ Perform the following steps:
A. Position the back cane bracket onto the seat pan and side rail in the position noted
in STEP 2A.
B. Secure the back cane bracket to the seat pan and side rail using the two hex screws,
washer, pin and two locknuts. Torque to 75 in‐lbs ± 20%.
C. Secure the side of the back cane bracket to the slot in the side rail using the hex
screw. Torque to 156 in‐lbs ± 20%.
D. Tighten the two hex screws on the remaining back cane bracket. Torque to 75 in‐
lbs ± 20%.
3. Secure the seat pan to the seat frame using the screws and locknuts. Tighten securely.
NOTE: Wheelchairs with power elevating legrests have two screws (FIGURE 12.1 on page 70)
and wheelchairs without power elevating legrests have three screws (FIGURE 12.2 on page 71).
4. Install the seat cushion (not shown).