Jaguar bluetooth handbook JLM10 31 99 552 - Manual (Page 10)

10
Quick Overview
L
AUDIO SYSTEM
The buttons used in the following Audio
System instructions:
Switching ON the ignition
Each time the ignition is switched on, the
following screens may be displayed.
This screen may be displayed for a few
seconds while the system is performing a
self-check.
Do not take any action. However, should
the screen stay on for longer than twenty
seconds, switch the ignition OFF and wait
for at least 6 minutes. Refer to Reason for
Ignition OFF for 6 Minutes, page 12 for
more information.
After the brief system check, you should
see the following screen:
This screen will be displayed to indicate
one of two possible conditions:
1. There is no phone currently Paired to
the vehicle system or no phone is
available. Should this be the case, this
screen will continue to be displayed
while the system is in phone mode
(the system may display the SIG****
or SIG***** screen ready for you to
Pair your Bluetooth mobile phone).
2. Displayed only for a few seconds if a
phone IS Paired, but whilst the system
is booting-up and looking for a Paired
device. If the last Paired phone is
available and switched on in
Bluetooth mode, then the screen
changes from SIG to SIG*.
Phone Mode button, to
manually select the phone
mode. Located to the left of the
Audio panel display.
Send/End button. Located to
the left of the Audio panel
display.