Jaguar bluetooth handbook JLM10 31 99 552 - Manual (Page 12)

12
Quick Overview
L
Downloading your phonebook entries
The Phonebook entries on your mobile
phone can be downloaded from your
phone to the vehicle system, dependent
on the capability of the mobile phone.
For more information, refer to the specific
Quick Guide (available from your Jaguar
Dealer or Authorised Repairer) for your
phone.
The following process will only work with
specific phones. The phone must be ON
and already Paired with the Jaguar
system.
1. Press the vehicle phone mode button.
(If not already in Phone Mode.)
2. Use the Audio panel keypad to enter
the key sequence ##2#*#, followed by
pressing the Send/End button.
3. To use or access your phonebook
immediately after Pairing:
Switch OFF the ignition for 6 minutes,
to allow the vehicle Bluetooth system
to complete the download process.
4. Switch ON the ignition.
The download should now have
completed successfully.
Note: Should you not wish to switch off
the ignition for 6 minutes at this time, the
phone book will be displayed after the
next normal ignition off cycle that elapses
for that duration.
Reason for Ignition OFF for 6 Minutes
The Bluetooth phone module in the
vehicle remains active for 6 minutes after
the ignition has been switched off.
It is important to wait this 6 minutes so
that a clean boot-up of the Bluetooth
module is achieved and the correct
information is stored.
Once a phone has been Paired with the
vehicle system, it will not need to be done
again unless the vehicle battery is
disconnected, or possibly if the system
closes down for security reasons, or if you
choose to Pair a different phone with the
system - only one phone at any time can
be Paired with the system.