Jaguar bluetooth handbook JLM10 31 99 552 - Manual (Page 6)

6
Quick Overview
L
Quick Overview
INTRODUCTION
Bluetooth communication operates
between bluetooth equipped devices; in
this case, the Jaguar Touch-screen
System or Audio System and a mobile
phone.
There are a limited number of mobile
phones (currently ten) that have been
tested and proved to function correctly
with the Jaguar system - ask your Jaguar
Dealer for details.
Before any phone can operate with the
Jaguar system, it must be Paired with the
system.
This involves the phone and the Jaguar
system communicating a unique code
between them, at initiation, so that in
future they each recognise one another.
When Pairing any phone with the Jaguar
system make sure that the phone is
switched on, the phone battery is fully
charged and the User's Handbook for the
phone is available.
This Quick Overview describes the
Touch-screen System first (Page 6),
followed by the Audio System display
(Page 10).
The Bluetooth system is identical for both
the Touch-screen and the Audio displays,
the difference is only in the way that the
information is presented to the user.
TOUCH-SCREEN SYSTEM
Icons and buttons used in the following
Touch-screen instructions:
Switching ON the ignition
Each time the ignition is switched on, the
following screens may be displayed.
This screen may be displayed for a few
seconds while the system is performing a
self-check.
Do not take any action. However, should
the screen stay on for longer than twenty
seconds, switch the ignition OFF and wait
for at least 6 minutes. Refer to Reason for
Ignition OFF for 6 Minutes, page 8 for
more information.
After the brief system check, you should
see the following screen:
Phone Mode button, to
manually select the phone
mode. Located to the left of the
Touch-screen.
Send/End icon. Located on the
Touch-screen.