Jaguar bluetooth handbook JLM10 31 99 552 - Manual (Page 9)

9
Quick Overview
R
Once a phone has been Paired with the
vehicle system, it will not need to be done
again unless the vehicle battery is
disconnected, or possibly if the system
closes down for security reasons, or if you
choose to Pair a different phone with the
system - only one phone at any time can
be Paired with the system.
To pair a different phone with the
system
If you attempt to Pair a different phone
immediately after switching ON the
ignition and the last Paired phone is NOT
available, you will have 2 minutes within
which to enter the the digit sequence
##3#*# to put the system into Discover
Me mode.
This is because, when the ignition is
switched ON, the system is looking for the
last Paired phone and if it does not find it
the system will revert to the Handset in
Use screen.
To Pair a different phone, select Phone
Mode and use the keypad to enter the
following digit sequence ##3#*#.
Press the green Send/End icon to initiate
the Pairing process again and to overwrite
the previously Paired phone.
Then, refer to Page 7 at the Discover Me
screen.
If the screen displays - Registered
If the ignition is switched to Accessory or
to the ON position for a short period of
time, then switched OFF and ON again,
the message displayed subsequently may
change to Registered (instead of
Discover Me or No BT Phone or Phone
Connected).
This is not due to a fault. It is because the
system has sensed an incorrect
shut-down of the Bluetooth module - that
is, it has not been allowed to follow its
normal closing down procedure time of
6 minutes.
However, the state of the five bars still
indicates the correct (current) status of
the system. You can still Pair a phone to
the system and use the system as normal.
When the system changes from one
mode to another (for example, Discover
Me to Phone connected) the Registered
message will disappear.