Jaguar bluetooth handbook JLM10 31 99 552 - Manual (Page 22)

Getting Started
22
L
Vehicles without touch-screen
Follow these steps to pair your phone
with the vehicle:
• Switch the vehicle’s ignition ON
(position II).
• Press the button on the audio
panel. SIG will be displayed.
• Using the audio panel keypad, enter
the code ##3#*# and press the
button.
It is recommended to use the code
##3#*# to pair your phone because
this code has no automatic time-out
period.
• SIG**** will be displayed.
• Switch on your mobile phone’s
Bluetooth connection, using the
phone’s menu. (Refer to the manual
for of your specific phone).
• Select search for other Bluetooth
devices or Audio Accessories from
your mobile phone’s menu.
• Select Jaguar in your phone’s paired
device list, in order to connect to the
vehicle’s Bluetooth system.
• Enter the Passkey on your mobile
phone (the Passkey is 1313). SIG will
be displayed initially.
• Once the vehicle and phone are
paired, SIG * will appear on the audio
panel.
Once a mobile phone is paired with the
vehicle, SIG will be displayed initially
when the ignition is switched ON. SIG*
will then be displayed, once the phone is
detected.
If the phone is not detected within two
minutes (after switching ON the ignition),
the audio system will exit phone mode
and revert to its previous audio mode.
Note:
• Once a mobile phone is paired with
the vehicle, SIG***** will be displayed
initially when the ignition is switched
ON. If no phone is detected, the
message SIG will confirm that no
phone is connected after
approximately two minutes.
• If an incorrect Passkey is entered, your
mobile phone should prompt you to
enter the correct Passkey.