Jura Capresso Impressa 68193 - Manual (Page 13)

• Never fill anything but fresh, cold clean water into the water
container, except when decalcifying (chapter 17.1).
• Never use mineral or carbonated water. You can use tap
water, bottled water, spring water, distilled water and reverse
osmosis water.
• Never repair or open the machine yourself. All repairs should
be performed only by an authorized service center.
• Do not place the machine on a surface which is sensitive to
hot or cold water and steam. Never place the machine on an
uneven surface.
PLEASE, DO...
• Fill water tank daily with fresh, cold water.
• Before filling the bean container, remove any foreign particles
(small stones) from coffee beans.
• Let frozen beans thaw for 3 to 4 hours before pouring them
into the bean container.
Important: If you pull out the drawer at any time you must empty
the used coffee container and the drawer. If you do not empty the
container, used coffee will overflow inside the machine and can
cause serious damage to the internal mechanism.
5. FACTORY SETTINGS / OPTIONS
The IMPRESSA S9 One Touch can be set up in many different
ways. Beverages, on/off settings, temperature, rinse cycles,
water treatment, energy savings modes and display information
can be programmed to your personal preferences.
Beverage buttons can be customized with regards to volume
(cup size), coffee strength (
AROMA ), temperature, duration of
milk steaming/frothing.
Coffee volume:
• All 1-cup buttons can be programmed to brew between
0.5 and 8 oz. of coffee.
• The Hot Water Portion can be programmed to dispense up to
15 oz. of hot water.
• All 2-cup buttons can be programmed to brew between
0.5 and 8 oz. per cup, total of 16 oz. max.
Tip: if you use a 12 oz. mug and program one of the 2-cup
buttons to 5 oz. the S9 OT will brew a total of 10 oz. of coffee
into your mug.
Coffee strength ( AROMA ):
• All 1-cup buttons can be set to five different coffee strengths:
XMILD , MILD , NORMAL , STRONG , XSTRONG .
In XMILD the conical burrs grind for approx. 5 seconds, in
XSTRONG, the grinding takes about 9 seconds.
• When using the 2-cup buttons, the S9 OT will always grind in
XSTRONG.
Please note: The display indicates the five strength settings with
graphics showing from one to five coffee beans.
Temperature:
• All coffee buttons can be set to
NORMAL or HIGH .
• The Hot Water function can be set to LOW , NORMAL , XHIGH
(XHIGH is used for pre-warming cups and for specialty teas).
Steaming for milk frothing:
• The cappuccino and latte macchiato buttons and the milk
portion can be set to produce steam from 3 to 120 seconds.
Latte Macchiato Pause:
• The pause between milk frothing and coffee brewing can be
set from 0 to 60 seconds.
13.