Jura Capresso Impressa 68193 - Manual (Page 24)

13c. MANUAL CLEARYL REPLACEMENT
If the filter is more than 2 months old and the display does not
indicate to replace filter, replace as follows.
COFFEE READY .
• Push the Rotary Dial until the display shows MAINTENANCE .
• Push Rotary Dial again, display shows CLEAN CAPPUCCINO .
• Turn the Rotary Dial until the display shows CHANGE FILTER .
• Push the Rotary Dial. The display shows DURATION 2 MIN./
START YES .
• Push Rotary Dial again. Display shows INSERT FILTER /
PRESS STEAM .
• Now install as explained in chapter 13a, steps 4 through 6.
13d. DO NOT LET THE CLEARYL FILTER DRY OUT!
If the filter is not immersed in water for a few days the granular
inside will dry out and block any water from passing through.
• If machine is not used for a few days, leave some water in the
water tank so the filter will not dry out. Upon using the
machine again, fill the water tank with fresh water and process
approx. 2 oz. of water through the hot water spout. You now
have fresh water for your first cup of coffee.
• If the machine is not used for a longer period of time, empty
the water container and remove the CLEARYL filter. Fill a
glass with at least 2 inches of water and immerse the filter.
Place the glass in the refrigerator.
• When you use the machine again, install the filter.
14. PROGRAMMING
The S9 OT provides programming, maintenance
and look-up functions. With the display at
COFFEE READY
you can access the following functions:
• Push the Rotary Dial until display shows MAINTENANCE .
Turning the Rotary Dial clockwise the display shows the follow-
ing functions:
MAINTENANCE .............. 15.1
PRODUCTS ..................... 14.1 (beverage buttons)
FILTER NO or YES ........... 13a
HARDNESS 10ºDh .......... 12b If FILTER YES this function is suppressed.
ECONOMY MODE – ........ 14.3
TIME --.-- ......................... 14.4
UNIT ON/OFF ................... 14.5
OFF AFTER ...................... 14.6
RINSES ............................. 14.7
INFORMATION ................. 14.8
SETTING AM/PM / OZ .. 14.9
LANGUAGE ENGLISH ..... 14.10
EXIT
Please note: to get back to COFFEE READY , turn the Rotary
Dial until the display shows EXIT , then push the Rotary Dial.
14.1 RE-PROGRAMMING BEVERAGE BUTTONS ( PRODUCTS )
This program allows you to change all parameters for all bever-
age functions.
The following parameters can be changed, where applicable:
Coffee volume (
WATER ): for all 1-cup buttons from 0.5 to 8 oz.,
for all 2-cup buttons from 0.5 to 8 oz. per cup (max total 16 oz.)
Coffee strength (
AROMA ) for all 1 cup buttons choose from five
settings: XMILD , MILD , NORMAL , STRONG , XSTRONG . The
display shows from one to five coffee beans to indicate the
selected strength during brewing.
24.
Chapter