Jura Capresso Impressa 68193 - Manual (Page 21)

The temperature for this function can be set to LOW, NORMAL
and XHIGH (chapter 14.1; example 3)
You can override the WATER PORTION during the hot water
release with the Rotary Dial.
You can re-program the hot water portion (chapter 14.1).
11. VISUAL PROGRAMMING OF BEVERAGE PORTIONS
Chapters 14 and 14.1 explain how to re-program all parameters
(volume, strength, temperature) for the beverage buttons.
Re-programming the cup size for coffee and milk can also be
done during beverage preparation as follows:
• Push and hold the beverage button you want to re-program
until display shows ENOUGH COFFEE? or ENOUGH MILK?
This way you can make sure your (cappuccino) cup is
completely filled with milk and coffee.
Example:
Visually re-programming the Cappuccino button (Fig 3.6).
COFFEE READY .
• Prepare the Cappuccino Systems (milk container etc) to make
a cappuccino and place your cappuccino cup under the
frothXpress.
• Push and hold the Cappuccino button until display shows
ENOUGH MILK?
• When the desired amount of milk and milk froth is in your cup,
push the Cappuccino button again. The display now shows
ENOUGH COFFEE?
• When enough coffee has been added to your frothed milk
push the Cappuccino button again. CONFIRMED ✓ , then
ENJOY , then COFFEE READY .
The next time you push the Cappuccino button, the S9 OT will
produce that amount of milk and coffee.
12. WATER CARE
The S9 OT works with: • tap water • bottled water • distilled
water. We recommend using tap water or bottled water. Distilled
water has no minerals and does not improve the taste of coffee.
Water that is heated inside the machine leads to calcium deposits.
Tap water has a varying degree of water hardness (chapter 12a).
Most bottled water has a low level of water hardness.
IMPORTANT: do not use carbonated water or any other liquid in
the water tank.
You have the following options to take care of the water.
• Decalcifying System (chapter 17.1).
• Clearyl Water Filter Cartridge (chapter 13a).
The machine is factory pre-set to automatically remind
you to decalcify.
12a. WATER HARDNESS MONITOR
Your S9 OT is set to a water hardness of
10ºdH and will auto-
matically indicate when it is time to perform a decalcifying cycle.
You can change the water hardness setting from 1º to 30ºdH. If
you are not sure about the hardness of your water, ask your local
water company for the "Water Hardness in Grains." The machine
displays the water hardness in the German hardness scale which
is a bit different from the American "Grain" scale (see chart
below). You can also use the water hardness indicator strip
("Aquadur" in Welcome Pack) to determine the water hardness:
• Insert the strip for one second into the water you want to
use. Shake off any access water and wait for one minute.
21.