Jura Capresso Impressa 68193 - Manual (Page 32)

If you use the frothXpress extensively or forgot to clean it, milk
fat starts building up inside the frothXpress. In this case use the
Cappuccino Cleaner liquid in the Welcome Pack.
Run a
CLEAN CAPPUCCINO cycle as follows:
COFFEE READY .
• Push the Rotary Dial until the display shows MAINTENANCE .
• Push the Dial again, CLEAN CAPPUCCINO .
• Push the Dial again. CLEANER FOR CAPPU. The Rinse
button illuminates.
• Pour approx. 5 oz. of water into a container and add one
capful (15 ml or 1/2oz.) of the Cappuccino Cleaner liquid.
• Immerse one end of the long milk hose into the cleaning
solution and insert the other end into the frothXpress. Turn
the frothXpress Dial to the 12 o’clock position.
• Place a container under the frothXpress (Fig. 4).
• Push the rinse button.
CAPPUCCINO CLEANS . The S9 OT
siphons the cleaning solution through the frothXpress and
stops automatically.
• When the display shows WATER FOR CAPPUCCINO ,
remove both containers and empty. Fill fresh water into one
container and insert the hose again. Place the other empty
container under the frothXpress.
• Push the Rinse button again. CAPPUCCINO CLEANS .
The S9 OT will siphon fresh water through the frothXpress,
removing the cleaning solution.
COFFEE READY .
• Squeeze the bottom of the venting tip (Fig. 17a) to make sure
it is clean.
You can also immerse the frothXpress parts (except the chrome
plated face) into a cappuccino cleaner solution as follows:
• Remove the frothXpress from the steam nozzle.
• Take the frothXpress apart (Fig. 17a) and set the chrome plated
face aside.
• Place all parts other parts including the hose in a cup with
warm water and add one cap-full (15 ml or 1/2oz.) of the
cappuccino liquid.
• Let sit for ten minutes or overnight.
• Rinse all parts under fresh water and assemble.
16. AUTOMATIC CLEANING CYCLES
16.1 CLEANING WITH SPECIAL TABLET
The machine monitors how many coffees are brewed and how
often the rinsing program is activated. After approx. 220 coffees
the display shows
COFFEE READY / CLEAN MACHINE . You
can continue brewing coffee, however we highly recommend
that you clean the machine as described below within the next
few days. This cleaning program will remove oil build-ups in the
brewing chamber. If the display shows
CLEAN NOW clean the
machine immediately.
This cleaning program takes about 20 minutes. Please use the
enclosed white cleaning tablet. The machine comes with a pack
of 2 tablets. To re-order see chapter 20.
Important: Once the cleaning program has started do not
interrupt the procedure.
COFFEE READY / CLEAN MACHINE
1. Push the Rinse button. DURATION 20 MIN. / START YES .
Please note: To clean the S9 OT at a later time, turn the Rotary
Dial until the display shows
START NO . Push the Rotary Dial to
32.