Jura Capresso Impressa 68193 - Manual (Page 22)

One or more sections of the indicator strip will turn reddish.
• Change the water hardness setting according to the table
below.
Please note: If you use Spring or Bottled Water with low calcium
levels you can set the hardness to 3ºdH, "extremely soft water".
12b. CHANGING THE WATER HARDNESS MONITOR
COFFEE READY
Example: change the hardness setting from 10ºdH to 20ºdH
• Push the Rotary Dial until display shows
MAINTENANCE .
• Turn Rotary Dial until the display shows HARDNESS 10º DH .
• Push the Rotary Dial to enter the program.
• Turn the Rotary Dial until the display shows
20ºdH .
• Push the Rotary Dial to confirm the setting. CONFIRMED ✓
and then HARDNESS 20ºdH.
• Turn the Rotary Dial until the display shows EXIT .
• Push the Rotary Dial COFFEE READY .
The machine will automatically remind you when it is time to
decalcify (chapter 17.1).
Please note: You can set the hardness monitor to
INACTIVE .
In this case you must use distilled water. In this setting the
S9 OT will not remind you to decalcify the machine.
13. CLEARYL WATER FILTER CARTRIDGE
The machine comes with one Clearyl Water Filter Cartridge. The
Clearyl cartridge
• Reduces the water hardness up to 75%.
• Removes (if present) up to 85% chlorine, up to 90% lead, up
to 95% copper and up to 67% aluminum.
• Cleans the water through an upward current principle (Fig. 10)
just before the brewing cycle starts, ensuring freshly filtered
water every time you make coffee.
• Lasts for 75 liters (~2,500 oz.) of water or up to two months.
• Eliminates decalcifying except when using very hard water
(25 grains or higher), see chapter 12. In this case we recom-
mended to decalcify the machine once or twice a year.
• To reorder cartridges, see chapter 20.
22.
Display
German
Degree Equivalent
American
Grains Indicator Strip
number of
"reddish" fields
Display Level
Not Active* INACTIVE — — —
1. extremely soft water 1-4 1-5 None
2. soft water 5-9 6-11 1 to 2
3. medium water 10-14 13-18 2 to 3
4. hard water 15-19 19-24 3 to 4
5. very hard water 20-24 25-30 4 to 5
6. extremely hard water 25-30 32-38 All 5
*Not Active: You can only use this setting for distilled water.
Level 5 and Level 6: If the tap water falls into these two cate-
gories, decalcifying will be frequent. In this case bottled water is
recommended. Most bottled water has a low calcium level.
Please note: If your water has a high calcium content (level 5 or 6)
and you use the Clearyl Filter Cartridge we recommend to decalcify
the machine once or twice a year (chapter 17 and 17.1).