Jura Capresso Impressa 68193 - Manual (Page 15)

Oily Beans: Beans with an oily surface tend to stick together.
This may prevent a continuous flow of beans from the bean
container into the burrs. As a result the grinder does not grind
enough coffee and you might get weak or no coffee at all.
Stir the beans in the bean container just before grinding.
Alternatively, you can also pour the beans into an open bowl and
let them sit for about 5 hours. The oils will evaporate (this will
not change the taste of your coffee). Then fill the beans into the
bean grinder. Now beans will feed into the burrs more easily.
6c. TURNING THE MACHINE ON FOR THE FIRST TIME
• Make sure bean container and water tank are filled.
• Press the Main Power Switch in the back of the machine (Fig. 1b)
The On/Off button illuminates (Fig. 2.B).
• Push the On/Off button. The display shows FILL SYSTEM /
PRESS RINSE and the Rinse button (Fig. 2.E) illuminates.
• Place containers underneath the Auto Cappuccino System
and the Hot Water Spout (Fig. 4) and push the Rinse button
(Fig. 2.E).
SYSTEM FILLING . The machine will dispense a
small amount of water. HEATING UP / PRESS RINSE .
• Place cup underneath the dual coffee spout (Fig. 4) and press
the Rinse button (Fig. 2.E). MACHINE RINSING . The machine
will dispense a small amount of water. COFFEE READY .
Please note: You can only make coffee when the display reads
COFFEE READY .
• Place a cup under the coffee spout and push one of the coffee
buttons. The machine will grind and brew coffee. If the display
shows
FILL BEANS push one of the coffee buttons again.
• Discard the first two cups of coffee.
You are now ready to brew coffee.
6d. CUP ILLUMINATION
The cup illumination adds a dramatic touch to brewing coffee.
Providing the machine is plugged in, you can activate the cup
illumination for 3 minutes by pressing any button.
7. ADJUSTING THE GRINDER
IMPORTANT:
The grinding grade can only be adjusted while
the grinder is actually grinding.
Adjust the grinder to the roast of your coffee.
• Light roast: use a finer adjustment (smaller dots).
• Dark roast: use a coarser adjustment (larger dots).
• Open the cover of the bean container (Fig. 5).
• To adjust fineness, turn the grinding wheel during grinding to
the desired position (Fig. 9).
ATTENTION: Oily beans tend to stick together. Stir beans just
before grinding to ensure a proper flow of beans into the burrs.
Please note: If coffee does not flow through the Dual Coffee
Spouts in a constant stream, turn the wheel to a coarser setting.
8. DAILY PREPARATION
Fill the water container every morning with fresh, cold water. This
will enhance the taste of your coffee.
• Make sure the Main Power Switch is on (Fig. 1b). In this case
the On/Off button is illuminated.
• Push the On/Off button. The display shows WELCOME TO
JURA and then HEATING UP . After approx. 2 minutes the
display shows PRESS RINSE .
• Push the Rinse Button* (Fig. 2,E). Hot water will warm up all
internal parts and pump through the coffee spouts MACHINE
15.