Jura Capresso Impressa 68193 - Manual (Page 16)

RINSING . The water will be caught in the drawer underneath.
The rinse cycle stops by itself and the display reads: COFFEE
READY . You are now ready to make coffee.
*Note: S9 OT can be programmed to automatically start the
rinsing cycle after
HEATING UP is displayed (chapter 14.7).
8a. TURNING THE MACHINE OFF / RINSING
Before turning off the S9 OT, place containers under the Dual
Coffee Spouts and Auto Cappuccino System (Fig. 4).
When the S9 OT is turned off or turns itself off it will prompt for
short cleaning cycles as follows:
Only the Dual Coffee spouts were used: The S9 OT displays
MACHINE RINSING . For a few seconds hot water will be
dispensed through the Dual Coffee Spouts and through the
coffee spout of the Cappuccino section. The machine and the
display turn off.
The Auto Cappuccino Spouts and the Dual Coffee Spouts
were used: The S9 OT first displays
CLEAN CAPPUCCINO
and the Rinse button illuminates. If the Rinse button is not
pushed within the next ten seconds, the display shows
SPOUT
RIGHT / PRESS RINSE . Press the Rinse button. The S9 OT will
dispense some hot water through the coffee spout of the
Cappuccino section. It will then push some hot water through
the Dual Coffee Spouts and turn off.
Please note: When the S9 OT turns off you may hear a slight
hissing noise.
9. COFFEE PREPARATION
9a. PRE-WARM CUPS
In the morning pre-warm your cups with hot water through the
Hot Water Spout. Cold cups reduce the coffee temperature by
5º F to 10º F.
Place a cup under the Hot Water Spout, turn the Selector Dial
(Fig. 3.3) until the display shows
HOT WATER and push the
Selector Dial. The display shows TEMP. XHIGH and water will
flow into your cup. Push the Selector Dial again to stop and
discard the water.
COFFEE READY .
9b. BREWING COFFEE AND ESPRESSO
The machine has four pre-set coffee buttons,
1 ESPRESSO ,
2 ESPRESSI , 1 COFFEE , 2 COFFEES (Fig. 2).
All buttons are pre-set for coffee strength, coffee volume and
temperature (chapter 5).
• Place one or two cups underneath the Dual Coffee Spouts
and push the desired button. The machine will grind, tamp
and then brew the coffee. It uses a 2-step brewing process
(pre-brew phase), pauses for a few seconds, and then starts
the brewing process. The display will show the name of the
button you pushed, e.g.
1 ESPRESSO and the selected coffee
strength indicated by a bean graphic, e.g. 4 beans = strong.
Please note: when pushing any of the two-cup buttons, the
coffee strength is not displayed.
Important: After the brewing stops the machine will discard the
used coffee grounds. Please do not try to pull out the drawer
(Fig.1,18) during this operation. It can seriously damage the
machine.There is no need to pull out the drawer until the display
shows the message
EMPTY TRAY or EMPTY GROUNDS .
16.