Jura Capresso Impressa 68193 - Manual (Page 34)

17.1 DECALCIFYING PROCEDURE
COFFEE READY / DECALCIFY MACHINE
1. Push the Rinse button until display shows
DURATION 45 MIN. / START YES .
Please note: To start at a later time, turn the Rotary Dial to
START NO and push the Rotary Dial. The machine will still
display COFFEE READY / DECALCIFY MACHINE .
2. Push the Rinse button again, display shows EMPTY TRAY .
3. Remove and empty the tray and the used coffee container
and replace, display shows SOLVENT IN TANK .
Attention: If the tray and the used coffee container are empty,
you must remove the tray for approx. 20 seconds and then
replace it.
4. Remove the frothXpress system from the Auto Cappuccino
system (Fig. 16).
5. Remove the water container and empty.
6. Completely dissolve 3 of the large square decalcifying
tablets in a container with 20 oz. of water (0.6 liters) and
pour the solution into the water tank.
7. Replace water tank. SOLVENT IN TANK/PRESS RINSE
8. Place containers under the Auto Cappuccino system and the
hot water spout (Fig. 4).
9. Push the Rinse button. The display shows DECALCS and
the light in the Rinse button flashes during the operation.
The machine pumps the decalcifying solution in intervals
through the Cappuccino system and the hot water spout.
The display shows decalcifying status in the progress bar.
10. When display shows EMPTY TRAY , remove and empty the
containers. Then carefully remove and empty the tray and
the used coffee container and replace.
11. Display shows RINSE WATER TANK / FILL WATER TANK .
Remove the water tank, rinse thoroughly, fill it halfway with
fresh water and replace. The display shows
PRESS RINSE .
12. Place containers under the auto cappuccino system and the
hot water spout / coffee spouts (Fig. 4).
13. Push the Rinse button DECALCS .
14. The machine pumps fresh water through the system and
stops automatically. The display shows HEATING UP . When
the display shows MACHINE RINSING , hot water will flow
through the coffee spouts. EMPTY TRAY .
15. Remove and empty the containers. Then carefully remove
and empty the tray and the used coffee container and
replace.
COFFEE READY .
The machine will automatically remind you when it’s time to
decalcify again.
17.2 MANUAL DECALCIFYING
If you use very hard water it is possible that calcium builds up
prematurely. If your coffee does not come out as hot as before
it is a sign for calcium build-up. When this happens you can
manually start a decalcifying cycle as follows:
COFFEE READY
• Push the Rotary Dial until the display shows MAINTENANCE .
• Push the Rotary Dial, display shows CLEAN CAPPUCCINO .
• Turn the dial until the display shows DECALCIFY MACHINE
and push the dial. The display shows DURATION 45 MIN. /
START YES .
• Continue with the steps 2 through 15 from the chapter 17.1.
34.