Seiko Group BP-6000 - Manual (Page 21)

❏ Single sheets paper
1. Move the paper select lever qtoward the rear of the printer to the SINGLE
SHEET setting.
2. Set the print head adjustment lever w. In general, position 1 is used
for one-part paper. (See page 15)
3. Raise the paper rack to the vertical position and adjust the left
paper guide e to the proper position for the size of the paper being
used.
4. Place single sheet of paper against the paper rack and let it slide behind the platen.
5. Adjust the right paper guide so that it comfortably holds the paper in between the two paper guides.
6. Press the PARK key or the FF key to load the single sheet paper to the top-of-form position 17/72
inch (6mm) below the top edge of the paper. The top-of-form position can be adjusted from 0/72
inch to 180/72 inch (64mm) by using the front panel controls in the setup option.
7. The paper bail automatically lowers to press the paper against the platen when the leading edge of
the paper feeds more than one inch onto the platen.
If the paper is not loaded on the proper mark, the printer may
not detect the paper and will issue PAPER ERROR.
If the paper is not completely fed in, slightly push the paper downward. If it is still not fed in, look
in the TROUBLESHOOTING section.
1. Extension Arms
The extension arms are used to keep large size (Legal, B4) cut sheet paper from falling
behind the paper rack. When using the extension arms, pull the arm until it clicks and locks
in place.
2. RLF, M.RLF, TEAR OFF, PARK keys are invalid in the cut sheet paper.
A3 B4
Paper Size Marker
Left Paper Guide
Extension Arms
Right Paper Guide
Paper Select Lever
Note
Note
Notes
14
2. Setting up