Seiko Group BP-6000 - Manual (Page 42)

Setting top of form position
The top margin can be set using this function, anywhere from a minimum of 0/72 inch (0mm)
to a maximum of 180/72 inches (64mm) by increments of 1/72 inch.
Press the Up or Down arrow keys to increase or decrease the top margin setting, respectively.
P r e s s t h e E N T E R k e y t o s e l e c t t h e d e s i r e d
setting.
Paper width
This function sets the paper width to be used in the printer. Depending on the paper width the
print head will shift to the one half of the print width selected in this function to properly hold
the paper in place, and to eliminate the possibillity of paper jams during loading.
Setting maximum print line length
This function sets the maximum printable length of a line of text. This function clears the data
in the print buffer.
Note: Be sure to set the line width to 8 inches when using the paper of its width less than 8
inches. Otherwise, printing directly on the platen may cause an irregular printout or paper
skew.
1 LOADING ADJST
TOP: + 0/72IN
TOP: +nnn/72IN
TOP: +180/72IN
2 PAPER WIDTH
SINGLE: >9 IN
SINGLE: <9 IN
FANFOLD: >9 IN
FANFOLD: <9 IN
.................... Default setting for a cut sheet paper
.................... Default setting for fanfold paper
3 LINE WIDTH
WIDTH:13.6 INCH
WIDTH: 8 INCH
0/72~180/72 inches
(Setup #1 Loading adjust)
Printable area
Printable area
Printable area
0/72~180/72 inches
(Setup #1 Loading adjust)
35
5. Extended setup options (1-3)