Seiko Group BP-6000 - Manual (Page 46)

Skip over perforation
This function automatically leaves one inch of unprinted lines at the end of the page and
linefeeds the paper to the next top of form. If the page length is smaller than 5 inches, this
function is ignored. The skip perforation software command overrides this function.
Line Feed Speed
This function specifies the line feed speed. The 1/2 LF speed feeds paper more stably. It is
useful for thick paper, labeled sheets and multipart paper in continuous printing.
Set CSF (cut sheed feeder) type
A function for defining the CSF configuration. The CSF type, single tray or double tray canbe
set when the CSF is installed. See "Options and expendables" on page 4.
When either single or double CSF is selected, the paper tray (bin 1 for single CSF and bin 1
and 2 for double CSF) can be selected by the BIN key on the front control panel.
39
5. Extended setup options (11-13)
11 1-INCH SKIP
1-INCH SKIP:NO
1-INCH SKIP:YES
.................... Defaults to non-skip over perforation.
12 LF SPEED
LF SPEED:NORMAL
LF SPEED:1/2
13 CSF OPTION
INSTALLED:NO
INSTALLED:1 BIN
INSTALLED:2 BIN
.................... No CSF installed
.................... Single CSF installed
.................... Double CSF installed