Seiko Group BP-6000 - Manual (Page 91)

84
❏ Setup options control codes
T h i s c o m m a n d i s s p e c i a l l y d e s i g n e d t o a s s i s t y o u i n u t i l i z i n g t h e p r i n t e r t o i t s f u l l e s t
p o t e n t i a l . M o s t o f p r i n t e r ' s s e t u p o p t i o n s c a n b e a c c e s s e d a n d c h a n g e d t h r o u g h t h e
following command sequence.
Setup command sequence
Setup declare codes
(1B 7C 60 01 00 11 ) h Setup command codes
1B 7C 60 m1 m2 a 1 . . . a k
header
m 1 , m 2 : Number of data bytes
followed as parameters
(a1..ak). k = (m1 +
(
2 5 6 x m2 ))
Setup terminate codes
(1B 7C 60 01 00 12)h
1 . This command sequence is only valid when the Software setup is set to YES
( e n a b l e d ) i n t h e e x t e n d e d s e t u p o p t i o n s a t t h e f r o n t c o n t r o l p a n e l . T h e
command is treated as regular print data if the software setup is disabled.
2 . Always start the software setup commands with the setup declare code and end
by the setup terminate code.
3 . In order to store the parameters changed in the setup options through these
control codes, be sure to insert the "Save setup" function code before the setup
terminate codes.
N o t e s
B. Control code summary (Setup options)