Standard Horizon Gx5500s - Manual (Page 35)

Page 35 GX5500S
10.17.2 Calling
Hold down the [5(IC)] key when the “Intercom” mode is activated to send a
calling beep to the RAM+ or VH-310 remote mic.
NOTE
When both RAM+ microphones (or VH-310 Hand-
sets) are set to intercom mode, the GX5500S will
be temporarily disabled until the remote mics exit
the intercom mode.
10.18 VOICE SCRAMBLER
If privacy of communications is desired, an optional CVS2500 4 code voice
scrambler (VS) can be installed in the transceiver. Contact your Dealer to have
a CVS2500 installed.
1. Turn the CHANNEL selector knob to select the channel to be scrambled.
Note: Channel 16 and 70 can not operate the voice scrambler.
2. Press the [F] key followed by the [7(SCRM)] key,
the voice scrambler is activated. “ VS VS VS VS VS” and scram-
bler number (“ 0 0 0 0 0,” “1 1 1 1 1,” “2 2 2 2 2,” or “3 3 3 3 3”) will appear on the
LCD.
3. Press the [F] key, then press and hold down the
[7(SCRM)] key until “Scrambler Scrambler Scrambler Scrambler Scrambler” menu appears.
4. Turn the CHANNEL selector knob to change the
scrambler code. The scrambler code can be set from
“
0 0 0 0 0” to “3 3 3 3 3.”
5. Press the [ENT] key to save the scrambler code and return to radio opera-
tion mode (with voice scrambler).
6. Monitor the channel before transmitting.
7. To disable the voice scrambler, press the [F] key followed by the [7(SCRM)]
key again. “ VS VS VS VS VS” and scrambler number (“0 0 0 0 0,” “1 1 1 1 1,” “2 2 2 2 2,” or “3 3 3 3 3”) disappear from
the LCD.