Standard Horizon Gx5500s - Manual (Page 82)

GX5500S Page 82
[CLR] Key
Press the [CLR] key to cancel the menu selection and/or keypad entry.
[ENT] Key
Press the [ENT] key to enter the menu selection and/or keypad entry.
14.2 INTERCOM OPERATION
14.2.1 Communication
1. Press the [F] key followed by the [5(IC)] key, the mode is changed to “IN-
TERCOM” mode.
2. If your GX5500S is equipped with two VH-310 Handsets
(or RAM+ Mics), select the station you wish to communi-
cate (
RADIO RADIO RADIO RADIO RADIO, RAM RAM RAM RAM RAM, or ALL ALL ALL ALL ALL) with the [ T]/[S] key, then press
the [ENT] key.
3. When the “INTERCOM” operation is
activated, “IC” is displayed on the VH-
310 Handset (and RAM+ Mic, if used)
and “INTERCOM” is displayed on the
GX5500S.
4. Press the PTT switch, “TALK” is dis-
played.
NOTE: A warning beep is emitted
when the RAM+ Mic PTT switch is
also being pressed while the trans-
ceiver microphone’s PTT switch is pressed.
5. Speak slowly and clearly into the microphone, hold the microphone about
1.5 cm away from your mouth.
6. When finished, release the PTT switch.
7. To exit the “INTERCOM” mode and return to radio operation mode, press
the [F] key followed by the [5(IC)] key again.
14.2.2 Calling
Press and hold the [5(IC)] key for 1 second when the “INTERCOM” is acti-
vated, a calling beep is emitted from the GX5500S speaker.
(VH-310 Mic’s PTT switch is pressed)
(GX5500S’s PTT switch is pressed)