Sharp FODC550 - Manual (Page 24)

MAKING COPIES
22
Originals that cannot be used in the RSPF
The following originals cannot be used. These may cause misfeeds or smudging and
unclear images.
• Transparencies, tracing paper, other transparent or translucent paper, and
photographs
• Carbon paper, thermal paper
• Originals that are creased, folded, or torn
• Glued originals, cut-out originals
• Originals with binder holes
• Originals printed using an ink ribbon (thermal transfer printing), originals on
thermal transfer paper
Stream feeding mode
"SET ORIGINALS FOR STREAM FEEDING" will appear in the display for five
seconds after all originals are fed. If a new original is placed in the RSPF during this
time, the original will be automatically fed in and copying will begin with the same
setting. Stream feeding mode can be disabled in "STREAM FEEDING" in the user
programs (p.63).
Capacity of paper output tray
Paper output tray extension
When copying onto paper larger than 8-1/2" x 11" size, pull out the paper output tray
extension.
Paper holder arm
The paper output tray has a paper holder arm. The paper holder arm presses gently
on the output paper to stack it (p.9).
• The paper output tray can hold a maximum of 200 pages. If more
than 200 pages are allowed to accumulate, a paper jam may occur.
• After removing paper, if you need to return the paper to the paper
output tray, lift up the paper holder arm and place the paper under the
arm.
Maximum number of pages that can
be held in the tray: 200
Note
!03-making copies.fm 22 ページ ２００４年３月２５日 木曜日 午後４時３６分