Sharp FODC550 - Manual (Page 71)

69
8 Chapter 8
8
Problems related to general use of the machine, the copy function, and software
setup are explained here. Be sure to check the problem carefully before calling for
service, as many problems can be solved by the user.
If you are unable to solve the problem, turn off the main switch, unplug the power
cord from the outlet, and contact your SHARP authorized dealer.
DISPLAY MESSAGES
When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the indicated page.
For problems related to the fax, printer and scanner functions, see the
corresponding operation manuals.
Be sure to use only genuine SHARP parts and supplies.
Indication
Cause and remedy Page
Lamp indicator Display
Tray
location
indicator
Blinks
BYPASS : ADD
PAPER
The indicated paper tray is not closed,
is closed incorrectly, or has run out of
paper. (The tray is indicated in <*>.)
15
TRAY<*> : ADD
PAPER
CLOSE PAPER
TRAY<*>
Error
indicator
Blinks
CLEAR PAPER
JAM. A paper misfeed has occurred.
Remove the misfeed as explained in
"MISFEED REMOVAL".
79
SPF/RSPF JAM.
FRONT OR SIDE
COVER OPEN.
CLOSE COVERS.
The cover is open. Close the cover. -
CLOSE THE SPF/
RSPF COVER. The RSPF cover is open. Close the RSPF
cover.
82
REPLACE THE TD
CARTRIDGE. The TD cartridge is empty. Replace the
TD cartridge with a new cartridge.
84
SYSTEM ERROR
[XX - XX] REFER
TO USER GUIDE
When [L1-00] appears, the scan head
locking switch is locked. Turn off the
power, release the scan head locking
switch, and turn the power back on.
83
The machine will not function. Turn the
power switch off, wait about 10 seconds,
and then turn on the switch again. If this
does not clear the error, remove the
power cord from the outlet, and contact
your SHARP authorized dealer.
-
Note
Note
TROUBLESHOOTING AND
MAINTENANCE
FO-DC550_Copy(Sec).book 69 ページ ２００４年３月２５日 木曜日 午後３時４４分