Sharp FODC550 - Manual (Page 83)

TROUBLESHOOTING AND MAINTENANCE
81
8
2 Gently remove the misfed paper
from under the fusing unit as shown
in the illustration. If the paper cannot
be removed, proceed to "C: Misfeed
in the transport area".
3 Raise the fusing unit release lever and then close the side
cover by pressing the round projections near the side cover
open button. The error indicator will go out and the ready
indicator will light up.
C: Misfeed in the transport area
1 Lower the fusing unit release lever.
See "B: Misfeed in the fusing area" (p.80).
2 Open the front cover.
To open the front cover, see "TD CARTRIDGE REPLACEMENT" (p.84).
3 Rotate the roller rotating
knob in the direction of the
arrow and gently remove the
misfed paper from the exit
area.
The fusing unit is hot. Do not touch the fusing unit when
removing misfed paper. Doing so may cause a burn or other
injury.
• Do not touch the surface (green portion) of the drum cartridge when
removing the misfed paper. Doing so may cause damage the drum
cartridge and smudges on copies.
• Do not remove the misfed paper from above the fusing unit. Unfixed
toner on the paper may stain the paper transport area, resulting in
smudges on copies.
Warning
Caution
Roller rotating
knob
FO-DC550_Copy(Sec).book 81 ページ ２００４年３月２５日 木曜日 午後３時４４分