Sharp FODC550 - Manual (Page 46)

SET UP THE SOFTWARE
44
This completes the installation of the software.
• If you installed Button Manager, set up Button Manager as explained in "SETTING
UP BUTTON MANAGER" (p.51).
Windows 98/Me/2000 (USB)
1 The USB cable must not be connected to the machine. Make
sure that the cable is not connected before proceeding.
If the cable is connected, a Plug and Play window will appear. If this
happens, click the "Cancel" button to close the window and disconnect the
cable.
2 Perform steps 2 through 7 in "CUSTOM INSTALLATION" (p.40 -
p.41).
3 Click the "MFP Driver"
button.
To view detailed information on
the software, click the "Display
Readme" button.
4 The "Welcome" window will appear. Click the "Next" button.
If you are running Windows XP and a warning message appears
regarding the Windows logo test or digital signature, be sure to click
"Continue Anyway".
A "USB 2.0 Composite Device" installation window may appear prior to
this procedure. In this case, follow the instructions in the window to
install the USB 2.0 Composite Device.
The cable will be connected in step 9.
Caution
Note
Note
FO-DC550_Copy(Sec).book 44 ページ ２００４年３月２５日 木曜日 午後３時４４分