Sharp FODC550 - Manual (Page 27)

25
3
REDUCTION/ENLARGEMENT/ZOOM
Copies can be reduced down to 25% or enlarged up to 400%. (When the RSPF is
being used, the zoom copy ratio range is 50% to 200%.) The [COPY RATIO] key can
be pressed to quickly select a ratio from among eight preset ratios. In addition, the
[
] key ( ) and [ ] key ( ) can be pressed to select the ratio in increments of
1%.
1 Place the original(s) and check the paper size.
2 Press the [COPY RATIO] key.
3 Press the [COPY RATIO] key and/or [ ] key ( ) or [ ] key
( ) to select the desired copy ratio and then press the
[ENTER] key.
Selecting a preset ratio
The preset ratios change as follows each time the
[COPY RATIO] key is pressed:
"100%"
→ → → → "78%" → → → → "64%" → → → → "50%" → → → → "25%" → → → →
"400%"
→ → → → "200%" → → → → "129%".
Fine adjustment of the ratio
The ratio can be adjusted from 25% to 400% in
increments of 1%. (When the RSPF is being used,
the zoom copy ratio range is 50% to 200%.)
Use the [
] key ( ) or the [ ] key ( ) for
fine adjustment.
4 Select the number of copies and any other copy settings, and
then press the [START] key (
).
The copy will be delivered to the paper output tray.
• To return the ratio to 100%, press the [COPY RATIO] key until 100%
appears.
• Press the [COPY RATIO] key to set the approximate ratio, then press
the [ ] key ( ) or [ ] key ( ).
• To decrease or increase the zoom ratio rapidly, hold down the [ ]
key ( ) or [ ] key ( ).
The ratio will stop changing at each of the preset ratios. To continue
changing the ratio, release the key and then hold it down again.
COPY RATIO
- 100% +
8.5x14 TO 8.5x11
- 78% +
ZOOM
- 99% +
Note
FO-DC550_Copy(Sec).book 25 ページ ２００４年３月２５日 木曜日 午後３時４４分