Print mode – Sharp FODC550 User Manual
Page 68
USER SETTINGS
66
Print mode
*
1
The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED",
however, the printing speed does not increase considerably.
*
2
When the 250-sheet paper feed unit is installed.
Program
number
Program name
Setting codes
(factory default
setting appears
in bold)
Explanation
1
FORCED
OUTPUT
1: ON
2: OFF
• When this function is enabled,
printing in printer mode will
automatically continue using a
different size of paper if the
specified size of paper runs
out in all trays. This feature
does not function in copy
mode.
2
USB 2.0 MODE
SWITCH*
1
1: FULL-SPEED
2: HI-SPEED
• This sets the USB 2.0 data
transfer speed. To obtain the
fastest speed when using the
USB 2.0 connector, first verify
that your computer meets the
system requirements
(operating system and driver),
and then use this program to
change the USB 2.0 mode to
"Hi-Speed". Note that the
setting should not be changed
while running a TWAIN driver.
(For the system requirements,
see "System requirements for
USB 2.0 (Hi-Speed mode)"
(p.57).)
3
AUTO TRAY
SWITCH*
2
1: ON
2: OFF
• If the paper runs out during
printing and there is paper of
the same size in another tray,
this function automatically
switches to that tray
(excluding the bypass tray).
The function can be disabled.
FO-DC550_Copy(Sec).book 66 ページ ２００４年３月２５日 木曜日 午後３時４４分