SATO XL400/410 - Manual (Page 150)

150 SATO RISC Printers
4. Bar Code Specifications Programming Manual
With incrementing
<ESC>A
<ESC>H0100<ESC>V0100<ESC>F001+001
<ESC>BI04150101234567000000001
<ESC>Q2<ESC>Z
Output:
Note:
1. The Start, Function, Stop and Extension codes will be created by
the printer and added automatically.
2. The internal Modulo 10 check character will be automatically cre-
ated and added by the printer. The overall Code 128 symbol check
character will be automatically created by the printer and added.
3. The automatically created human readable text will be created
according to the following rules:
•
The spacing between the bar code and the text is fixed at 10
dots (.050 inches).
• If the width of the human readable text is wider than the bar
code, it will start at the same position as the bar code and
extend past the right of the bar code.
• If the width of the human readable text is less than the bar
code, it will be centered on the bar code.
• The automatically generated human readable font is OCR-B.
• If any part of the human readable text extends outside the
printable area, none of it will be printed. Care should be exer-
cised when placing the bar code to allow for any automatically
created human readable text.