SATO XL400/410 - Manual (Page 85)

Programming Manual 2. Command Codes
SATO RISC Printers 85
2. If using reverse images with the form overlay, place this com-
mand before the Form Overlay command in the data stream.
3. If the Rotate commands are used with this command, the V and
H parameters are reversed.
4. If the height and width to be reversed contain other than alpha-
numeric data, the area is not printed.
5. If the values specified exceed the maximum ranges, the reverse
image is not created.
6. The maximum allowable settings are:
7. The Reverse Image is not working in combination with Sequential
Numbering.
CL 408 CL 412 CL 608 (VA) CL 612 (VA)
Horizontal
aaaa -0832 to 0832 -1248 to 1248 -1216 to 1216 -1984 to 1984
Vertical
bbbb 0001 to 1424 0001 to 2136 0001 to 1424 0001 to 2136
M8485S M8490S M8460S M8459S
Horizontal
aaaa -1248 to 1248 -1344 to 1344 -1216 to 1216 -0896 to 0896
Vertical
bbbb 0001 to 1424 0001 to 2136 0001 to 1424 0001 to 2136
XL 400 XL 410 M8400RV
Horizontal
aaaa -0800 to 0800 -1200 to 1200 -0832 to 0832
Vertical
bbbb 0001 to 1920 0001 to 1920 0001 to 1920