SATO XL400/410 - Manual (Page 31)

Programming Manual 2. Command Codes
SATO RISC Printers 31
Note:
1. Use of this command will set the Vertical/Horizontal Offset setting
of the printer configuration until a new Base Reference Point
command is issued or the setting is changed from the operator
panel.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your
current Horizontal and Vertical Print Position commands.
Example:
Let’s say the current base reference point is H=1, V=1 and you
wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point com-
mand or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point com-
mand, see “Print Area” in this section.
5. The allowable field ranges for this command are:
CL 408 CL 412 CL 608 (VA) CL 612 (VA)
Horizontal
aaaa -0832 to 0832 -1248 to 1248 -1216 to 1216 -1984 to 1984
Vertical
bbbb 0001 to 1424 0001 to 2136 0001 to 1424 0001 to 2136
M8485S M8490S M8460S M8459S
Horizontal
aaaa -1248 to 1248 -1344 to 1344 -1216 to 1216 -0896 to 0896
Vertical
bbbb 0001 to 1424 0001 to 2136 0001 to 1424 0001 to 2136
XL 400 XL 410 M8400RV
Horizontal
aaaa -0800 to 0800 -1200 to 1200 -0832 to 0832
Vertical
bbbb 0001 to 1920 0001 to 1920 0001 to 1920