SATO XL400/410 - Manual (Page 43)

Programming Manual 2. Command Codes
SATO RISC Printers 43
Note:
1. Use the Print Position commands (V and H) to locate the new area
for the duplicate image.
2. Position of the new target area must not be inside the original
image.
3. If you use the Rotate command, V, H, X and Y axis will be reversed.
4. If the reference area of the target image exceeds the print area, it
will not be printed.
5. The allowable field ranges for this command are:
CL 408 CL 412 CL 608 (VA) CL 612 (VA)
Horizontal
aaaa 0 to 0832 0 to 1248 0 to 1216 0 to 1984
Vertical
bbbb 0001 to 1424 0001 to 2136 0001 to 1424 0001 to 2136
M8485S M8490S M8460S M8459S
Horizontal
aaaa 0 to 1248 0 to 1344 0 to 1216 0 to 0896
Vertical
bbbb 0001 to 1424 0001 to 2136 0001 to 1424 0001 to 2136
XL 400 XL 410 M8400RV
Horizontal
aaaa 0 to 0800 0 to 1200 0 to 0832
Vertical
bbbb 0001 to 1920 0001 to 1920 0001 to 1920