SATO XL400/410 - Manual (Page 62)

62 SATO RISC Printers
2. Command Codes Programming Manual
Note:
1. This command can be used for text as well as for bar codes.
2. It is effective only for the current data stream.
3. When printing lines or boxes in the same data stream with the
Line Feed command, the Lines and Boxes command should be
specified last, preceding <ESC>Q Quantity command.
4. This command is invalid only if the value specified is zero.
5. The rotation command can be used with this command.
6. Following this command with a <CR> character will allow you to
print with auto line feed. In this case, the print position will be
determined from the value specified in the command and the H
value set in the printer. However, if you specify several H values
after this command, the print position will be determined by the
H value last specified. You must redefine the font to be used after
each H command.