SATO CX208/212 - Manual (Page 24)

Special Notes 1. Use of this command will set the Vertical/Horizontal Offset setting
of the printer configuration until a new Base Reference Point
command is issued.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your
current Horizontal and Vertical Print Position commands.
Example:
Let’s say the current base reference point is H=1, V=1 and you
wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point
command, see “Print Area” in this section.
5. The CX208/212 printers will not “wrap” (i.e. if any part of a
character or image extends beyond the last print dot position, it
will disappear and not be visible on any part of the label).
6. The allowable ranges for the fields are:
Page 20 PN 9001092 Rev. A SATO CX208/212 Printers
CX208/212 Programming Guide
CX208 CX212
Horizontal
aaaa
0 to 0832 0 to 1230
Vertical
bbbb
0 to 1424
0 to 4060 0 to 2100
0 to 3780