SATO CX208/212 - Manual (Page 94)

Calibrate Sensor
Command Structure <ESC>CA
Example: <ESC>CA
Placement: This command should be sent after the sensor type
has been selected with the <ESC>CI command. It
should
not be included with print job commands.
Default: There is no default for this command.
Command Function To adjust the label sensor for unique media and ribbon combinations.
Input to Printer <ESC>A
<ESC>CI2
<ESC>CA
<ESC>Z
Printer Output There is no printer output for this command. It will cause the printer to
feed a label while the characteristics of the label backing or eye-mark
are measured.
Special Notes 1. The sensor is calibrated for the currently selected sensor type
(Eye-Mark or Transmissive).
2. If the Sensor is disabled with a <ESC>CI0 command, no
calibration is performed.
3. The sensor must be recalibrated whenever the sensor type is
changed.
4. When calibrating the sensor for the CX200/212TT Thermal
Transfer unit operating in the thermal transfer mode, the ribbon
must be installed in the printer.
Page 90 PN 9001092 Rev. A SATO CX208/212 Printers
CX208/212 Programming Guide