SATO CX208/212 - Manual (Page 64)

Special Notes 1. Specify the exact same parameters for the image to be replaced
as were specified in the original data stream, including rotation,
expansion, pitch, etc. This will ensure that the new data will
exactly replace the old image. If the replacement data contains
fewer characters than the old data, then the characters not
replaced will still be printed.
2. This command will not function if the power has been cycled off
and back on since the last label was printed.
3. Proportional Pitch text cannot be used with this command.
Page 60 PN 9001092 Rev. A SATO CX208/212 Printers
CX208/212 Programming Guide