Custom protocol command codes download – SATO CX208/212 User Manual
Page 95
Custom Protocol Command Codes
Download
Command Structure
<ESC>LD,a,b,c,d,e,f,g,h,i
a
=
Replacement character for STX in ASCII or hex format
b
=
Replacement character for ETX in ASCII or hex format
c
=
Replacement character for ESC in ASCII or hex format
d
=
Replacement character for ENQ in ASCII or hex format
e
=
Replacement character for CAN in ASCII or hex format
f
=
Replacement character for NULL or ~ in ASCII or hex
format
g
=
Replacement character for OFFLINE in ASCII or hex
format
Example:
<ESC>LD,{,},%,#,&,*,~,0,0
Placement:
Immediately following the <ESC>A Start command and
in
an independent data stream.
Default:
Standard Protocol command Codes
Command Function
Allows the user to defines custom Protocol Command codes.
Printer Input
<ESC>A
<ESC>LD,{,},%,#,&,*,~,0,0
<ESC>Z
Printer Output
A Protocol Command code status label will be printed as a result of
the a successful download of a custom set of Protocol Command
codes.
Special Notes
1. Commas must be used to separate the parameters. If a parameter
is omitted between two commas, the default Non-Standard
Protocol Command codes for that parameter will be used.
Page 91
PN 9001092 Rev. A
SATO CX208/212 Printers
CX208/212 Programming Guide
STX = 7B
ETX = 7D ESC = 25
ENQ = 23
CAN = 26 NULL = 2A
OFFLINE = 7E
Press the FEED key to activate the User
Default or power the printer off to ignore
them.