A n 9 3 – Silicon Laboratories SI2493/57/34/15/04 User Manual
Page 128
A N 9 3
128
Rev. 1.3
<EM><err>
0xB2 Transmit an Abort
Detected a non-flag to flag
transition.
Preceding data are not a valid
frame.
Yes
<EM><under>
0xB4 not applicable
Detected Transmit Data
Underrun
Yes
Yes
<EM><tover>
0xB5 not applicable
Detected Transmit Data Over-
run
Yes
Yes
<EM><rover>
0xB6 not applicable
Detected Receive Data Over-
run
Yes
Yes
<EM><resume
>
0xB7
Resume after a data
underrun or overrun
(applicable if
+ESA[C] = 1)
Not applicable
Yes
<EM><bnum>
0xB8 not applicable
<octnum0><octnum1> speci-
fies
number of octets in the trans-
mit data
buffer if +ITF[C] is non-zero2.
Yes
Yes
<EM><unum>
0xB9 not applicable
<octnum0><octnum1> speci-
fies
number of discarded octets fol-
lowing
a data overrun/underrun, after
the
<EM><resume> command.
This is
applicable if +ESA[C] = 12.
<EM><eot>
0xBA
Terminate carrier, return to
command mode.
Loss of carrier detected, return
to
command mode
Yes
Yes
<EM><ecs>
0xBB
Escape to On-Line com-
mand
mode
Confirmation of Escape to On-
Line
command mode.
Yes
Yes
<EM><rrn>
0xBC
Request rate renegotia-
tion
Indicate rate renegotiation
Yes
Yes
Table 86. EM In-Band Commands and Statuses (Continued)
Command–
Indicator pair
Hex
Code
Transmit Direction
Receive Direction
Supported
in
Transparent
Submode
Supported
in Framed
Submode