A n 9 3 – Silicon Laboratories SI2493/57/34/15/04 User Manual
Page 62
A N 9 3
62
Rev. 1.3
Ln
Speaker Volume
L1
Low
L2
Medium
L3
High
L4
Very High
Mn
Speaker operation (via AOUT).
M0
Speaker is always off.
M1
Speaker is on while dialing and handshaking; off in data mode.
M2
Speaker is always on.
M3
Speaker is off while dialing; on during handshaking and retraining.
On
Return to data mode from command mode.
O0
Return to data mode.
O1
Return to data mode and perform a full retrain (at any speed
except 300 bps).
O2
Return to data mode and perform rate renegotiation.
Qn
Response mode.
Q0
Enable result codes (See Table 43.)
Q1
Disable result codes (enable quiet mode)
R
Initiate V.23 Reversal (U53 bit 15 must be set.)
Sn
S-register operations (see Table 45)
S$
List contents of all S registers.
Sn?
Display contents of S-register n.
Sn=x
Set S-register n to value x (n and x are decimal values).
Vn
Result code type (See Table 43)
V0
Numeric result codes.
Table 39. Basic AT Command Set (Continued)
Command
Action