Sanyo DSR-2108 - Manual (Page 11)

4
Names of each part and connections
Rear panel
1 Video input terminal (VIDEO IN/LOOP OUT)
2 Video output terminal (S-VIDEO)
3 Monitor 2 video output terminal (MON2)
4 Video output terminal (MAIN)
5 Audio input/output terminal (AUDIO IN: CH1 - CH4/
OUT1)
6 VGA (Video Graphics Array) output terminal
Connects to the PC VGA monitor.
7 External sensor terminal (ALARM IN)
8 Network terminal (LAN: P5)
9 RS-232C terminal (RS-232C)
For maintenance purposes.
F RS-485 control terminal (RS-485: P6)
G System changeover switch (SWITCH)
TERMINATE: RS-485 termination switch (P11)
RSV: For maintenance purposes.
VGA: Monitor selection switch (P9)
PAL: Television mode (PAL/NTSC) switching switch (P9)
H Alarm output terminal (ALARM OUT: CH1 - CH4)
When the configured alarm output conditions are met, a
relay signal is output to one or more external alarm
devices connected to the alarm output terminals. These
terminals are normally open.
I Cooling fan
J Power socket
Basic connections
• Do not turn this unit on before all the connections are complete. Read the instruction manual of each unit carefully.
• Make sure each unit is connected properly as faulty connection may result in the unit emitting smoke and/or being damaged.
• Feed additional units with the same power source. Stored data may be lost.
1
2
3 4 5 6 7 8 9 F G H I J
POWER MODE AUTO MENU
Camera
(Sold separately)
Monitor
(Sold
separately)
Speaker with
built-in amplifier
(Sold separately)
Video monitor
(Sold
separately)
Video monitor
(Sold
separately)
This equipment is indoor use and all the ethernet
wiring are limited to inside of the building.
1 2 3 4
Maximum current: 0.5 A/125 VAC
Maximum voltage: 1 A /30 VDC
Power supply
External alarm device 1 - 4
L8HBT_WA(DSR-2116_2108)(GB).book 4 ページ ２００９年５月２７日 水曜日 午後４時５０分