Sanyo DSR-2108 - Manual (Page 60)

53
Main screen structure and function of each part
When connected to this unit, the live video of the camera is displayed on the main screen.
1 Video display area
Displays live video or playback video.
<Screen display method>
Can be switched using the operation button on the screen.
(P55)
• Multi-screen (multi-9 screen / multi-16 screen)
• Sequence (camera switch) display
• Full-screen display
☞
In DSR-2108, the only available multi-screen is multi-8
screen.
<Camera information>
The following camera information is displayed on each
camera video.
1 (Top left):
• Camera channel (CH1 - 16)
• Camera designation
To change the camera designation, go to the camera
designation settings (Site) screen in the set up menu.
(P63)
(When no camera is connected to the channel, the
message "No Camera" is displayed.)
☞
In DSR-2108, CH1 - CH8.
2 (Top right):
M: MOTION recording in progress (P17)
A: ALARM recording in progress (P18)
3 (Bottom right):
R: Recording in progress
4 (Bottom left):
A: Alarm output in progress (P54)
Memo: Video is shown in the same channel as the alarm
output terminal number.
2 Information display area
The following information is displayed.
1 Shows the used capacity of the hard disk of this unit
2 Communication bit rate and frame rate
To display, set in the set up menu in the general setting
screen. (P62)
3 Date and time information
For live video: Current date and time
For playback video: Recorded date and time
3 Operation panel (P54)
The view operation buttons are arranged on the panel.
4 Log window
The operation history is displayed as a list.
Displayed items: Type, Site, Event, Date/Time
Memo: Click [SEARCH] on the operation panel to switch the
screen to search mode. One part of the operation
panel display and one part of the log window display
change. (P59)
4
1
2
3
1 2 3
1 2
3 4
(The example shown is a multi-16 screen display.)
• Single-screen • Quad-screen
L8HBT_WA(DSR-2116_2108)(GB).book 53 ページ ２００９年５月２７日 水曜日 午後４時５０分