Live settings – Sanyo DSR-2108 User Manual
Page 41
LIVE settings
34
● Setting the SEQUENCE
Sets whether the output video automatically switches to the
MON2 terminal.
1
Select "SEQUENCE" using the control button ({|).
2
Set ON/OFF using the control button (}~).
ON: Automatically switches
OFF:
Does not automatically switch
● Setting the SEQUENCE-DWELL TIME
If "SEQUENCE" is set to ON, set the switching interval.
1
Select "SEQUENCE-DWELL TIME" using the control
button ({|).
2
Set the switching interval (1 - 10 seconds) using the
control button (}~).
● Setting the MON2 CHANNEL
Sets the channel that outputs the video to MON2 terminal.
<If "SEQUENCE" is set to OFF>
1
Select "MON2 CHANNEL" using the control button ({|).
2
Select the setting position using the control button (}~).
If "MON2 TYPE" is set to "FULL" set one channel if it is set
to "QUAD" set 4 channels.
3
Select a channel (1 - 16) using the control button
({|}~).
☞
In DSR-2108, CH1 - CH8.
4
Move the cursor back to "MON2 CHANNEL" using the
control button (}~).
<If "SEQUENCE" is set to ON>
1
Select "MON2 CHANNEL" using the control button ({|).
2
Select a channel using the control button ({|).
The factory default display hides the channel numbers.
3
To select ON or OFF for the automatic switch display
(channel number display) press the ENTER button.
4
Move the cursor back to "MON2 CHANNEL" using the
control button ({|}~).
F
MON2-OUT
MON2 TYPE
FULL
MON2 ON EVENT
ON
MON2 EVENT DWELL TIME
10 SEC
SEQUENCE
ON
SEQUENCE-DWELL TIME
10 SEC
MON2 CHANNEL
1 2 3 4
5 6 7 8
- - - -
- - - -
L8HBT_WA(DSR-2116_2108)(GB).book 34 ページ ２００９年５月２７日 水曜日 午後４時５０分