Sanyo DSR-2108 - Manual (Page 61)

Main screen structure and function of each part
54
Function of the operation panel
1
2
3
4
5
6
7
8
9
G
F
H
<16 channels>
3 Screen display switch button (P55)
☞
In DSR-2108, only multi-8 screen is available since the number of
available channels is 8.
4 Camera controller (Only for PTZ dome camera)
When clicking the controller button ( / ), the controller display
changes. (P58)
5 Audio controller
Adjusts the audio output of live video and playback video.
6 [SEARCH] button
Switches the main screen to search mode (P59)
7 [CAPTURE] button
Saving images (P57)
8 Recording button (P56)
9 Still button (P57)
F Alarm output switch button
G Menu button
H Exit button
-
: To sequence (automatic camera switch) display
: Changing the display to a multi screen (multi-16 screen/ multi-9 screen)
: Selecting a channel and switching to single-screen
display
: Switching to quad-screen display
SW
: For Pan/Tilt operations
: For Zoom/Focus operations
SW
: The audio is not output
: The audio is output
: Adjusts the output volume VOLUME
SW
: Sets recording function to ON (Recording to PC hard disk)
: Sets recording function to OFF
SW
: Freezes the live video on PC
: Unfreezes the live video on PC
: Switches the alarm output (ALARM OUT 1) on the back panel
to ON/OFF (A The red button light up when an alarm output is
in progress)
: Displays the set up menu screen (P62)
: Exits the software and closes the screen
: The display of the icon changes according
to the selection made.
1 Scrolling connected sites (Select Site)
To change the connection destination select
the site name of the connection destination
using the pull down menu.
(Normally the site name of the present
connection destination is displayed.)
2 Connect/Disconnect button
SW
SW
: Displays the [Connect] dialog for
connection (P52)
: Disconnects the connection
L8HBT_WA(DSR-2116_2108)(GB).book 54 ページ ２００９年５月２７日 水曜日 午後４時５０分